| carbon block |  | The combination of the ultimate in plastics extrusion and activated carbon technologies has transformed the future of carbon filtration. By incorporating powder activated carbon and small mesh structures with extrusion manufacturing methods, clean, consistent and economic filters termed ‘CARBON BLOCK’ are created. To cover all applications and constructed from all FDA approved materials Fileder has four ranges of such carbon blocks all with the advantages over traditional granular carbon of greater efficiency, longer life, higher flow, no channelling, lower extractables, fine filtration, cleaner and more versatile.
This section includes EPM, EP, CEP, CCBC, CBC, and VBR2 filters
click picture to view our carbon block range
|
|
|
| granular activated carbon |  | o Effective bad taste & odor and chlorine taste & odor reduction*
o Designed for maximum adsorption
o Post-filter to reduce carbon fines
o Available in a variety of sizes and flow rates
This section includes GAC, TSGAC, RFC and GAC-S filters
click picture to view our GAC range |
|
|
| Electroplating carbon |  | o Cellulose-free construction
o Resistant to chemical breakdown in both acidic and alkaline solutions up to 82oC
o Will not contribute to plating porosity or bitterness
o Integrated post filration layer to ensure that no carbon fines are bled into the plating bath
o End-cap gaskets are permanently molded onto the end-caps to ease in change-out of filter cartridges (gaskets cannot fall off into the filter housing during installation or removal of filters)
click picture to view our electroplating carbon range |
|
|
| powdered activated carbon |  | o Economically priced
o Provides sediment filtration and bad taste & odor and chlorine taste & odor reduction
o High dirt-holding capacity
o Available in three sizes and two micron ratings
o Recommended for chlorinated water supplies
This section includes C1, C2, C8, and NCP filters
click picture to view our PAC range |
|
|
| chlorplus chloramine removal cartridge |  | The introduction of the Chlorplus represents a vast leap forward in carbon design technology, with a higher chloramine removal than any of GAPS other granular or carbon blocks. The Chlorplus reduces chloramine levels to below the guideline 0.1 ppm from a 1 ppm feed for over 45,000 litres. As a pre-filter in renal applications, membrane life is extended, due to the absence of carbon fines, which are a common by-product of granular carbons.
click picture to view our chloplus range |
|
|
| oil adsorbing media |  | The OilOut-95 from teh SPECTRUM range has been principally designed to effectively remove, through absorption, dissolved and dispersed hydrocarbons efficiently from water, absorbing 3 times its own weight before change-out is required. As the cartrideg becomes exhausted, flow is not effected and no hydrocarbons are released. Each pass through the cartridge removes up to 95% of hydrocarbons with each 10" cartridge having a capacity of 360 grams in standard size an d1290 grams in its large diameter format (BB).
The SPECTRUM OilOut-95 is best suited to applications with <500 ppm total hydrocarbons, after coalescing or other such bulk removal, and as a cost effective polishing method. |
|
|
|
