Testomat 330 (F-BOB/808) indicator 141009

Clear Color Change for Water Hardness The indicator changes color when water hardness exceeds a set limit. The Testomat® 808 or F-BOB analyzer reads this change to check water quality: Green Light: Water hardness is below the target level. Red Light: Water hardness has reached or exceeded the limit, triggering alarms or regeneration cycles. Precise Monitoring at 3.0 °dH This indicator is designed for systems that use a 3.0 °dH (German Hardness) threshold, ensuring accurate monitoring across different units: 53.4 ppm (mg/L) as CaCO₃ 5.34 °fH (French Hardness) 0.534 mmol/L (Total alkaline earth ions) (Note: The official standard for part number 141009 is calibrated to the 3.0 °dH limit.) Protects Your Equipment By flagging when the 3.0 °dH limit is crossed, the indicator prevents scale buildup in important systems: Reverse Osmosis (RO) Pre-Treatment: Protects RO membranes from hard water scaling, which would reduce water quality and increase pressure. Commercial Softeners: Acts as an automatic quality check, confirming when softeners need regeneration before hard water enters the system. Boiler Feedwater Systems: Prevents scale in steam generators and boiler tubes, keeping heat transfer efficient. Easy Integration and Clean Dosing Direct Installation: The 500 ml bottle fits directly into the Testomat® 808, using the original tube and cap. This design prevents pouring mistakes and contamination. Micro-Dosing Precision: The formula is matched to the Heyl dosing pump, delivering a consistent ≈80 μL per analysis for accurate results over 6,250 tests. Warranty Compliance: Using the original 141009 solution avoids staining the measuring cell and protects the pump from wear, keeping your device's warranty valid.